Welcome to visit BNTET Burner website!

NEWS

View and oil burner principle

Writer: admin Time:2022-07-07 00:00 Browse:

Local low nitrogen gas burner gas burner is different from the low nitrogen gas burners more environmentally friendly low nitrogen, low nitrogen gas burner so why would it be more environmentally friendly? With the view of low nitrogen gas burners oil burner principle and the principle of View
	View and oil burner principle

View and oil burner principle
Assumes no fire lit, the flame detector can not detect the flame signal, and protection of machine enters incineration. Methanol burning machine indicated generally require flame signal is detected by the flame detector is determined by the incineration unit in a gas flowing in 2-3 seconds, and the flame was not protected when incinerated, incineration in incineration stick. Fuel burner assuming incineration after assertion machine warning lights, then it needs to wait at least 20 seconds after pressing the reset button again transferred from scratch claims. Incineration machine near a temperature not too high, otherwise it will affect the normal operation or damage to the burning means, in particular the control box, particularly carefully insulated furnace body, assumed to be sealed, rather than using a chassis device, to be more careful perhaps revealing the heat from the furnace mouth. Nearby burning machine should adhere to clean, no accumulation of flammable debris, assuming there is found for the pipeline connection at the fuel leak, review and clean up the insurance only sustainable use. Unstable voltage will burning machine components that make up part of the damage. Avoid incineration become wet water. Chimney planning should avoid strong field Kazamaki back firebox, which is equipped with a thermostat, and with the optional switch to avoid too frequent burning machine should adjust the thermostat, if each successive actuation and between spaced time is too short, or burning machine will not operate properly. Fuel pump disadvantage incinerator, after the fuel burning machine claimed assumed warning lights, then at least until after the demand for more than 20 seconds, press the reset button again to re-claimed. Did you know that heating only adjust the size depends on the size of the degree of intensity of the flame, furnace tube surface area and total heat transfer coefficient. Even if there is no contact not know, now you know we should immediately clear the extent of the strength of the flame, the stronger the flame, the furnace temperature is higher, the greater the temperature difference between the furnace and the oil flow, the greater the heat transfer, the flame function heating furnace tube teasing surface area, the greater the area of ​​the flame tube in contact with the flue gas, the more the amount of heat transferred; strength scheduling control method of fire mouth available.